2/4 Welder Rd,
Seven Hills NSW 2147

Call Us Today!

02 9674 2500

Menu Close

Accessories

H-Bar Profile

For joining Carbolite sheets together, attach joiner to rafter or purlin support. Place Carbolite sheets into the neoprene gaskets and push into H-Bar in position. Available for 8 mm , 10mm and 16mm twin wall polycarbonate.

RECOMMENDED SPACINGS ( SUBJECT TO CARBOLITE ENGINEER SPECS.) THESE APPLY TO ALUMINIUM STRUCTURES ONLY.

Carbolite Sheet ThicknessSheet CentresPurlin Spacings
 Sheet WidthSheet centres with H BarSheet WidthPurlin Spacings
8mm700mm725mm700mm 
8mm1050mm1075mm1050mm1600mm
8mm1220mm1245 mm1200mm1600mm
10mm1050mm1085 mm1050mm1600mm
16mm1050mm1085 mm1050mm1600mm

Please Note: Rafter and Purlin spacings are based on wind load as indicated in N/m2. As each project varies you should contact your Carbolite agent for information on minimum and maximum spacings.

Sheet centres with H Bar as depicted in photo above
Purlins: Members spanning side to side.
Spacings are based on the sheets being fixed on four sides. Maximum wind load 600 N/m2.

Spacings are based on the sheets being fixed on four sides.